source: trunk/MultiChannelUSB/adc_fifo.v@ 108

module adc_fifo
        #(
                parameter       W       =       48 // fifo width
        )
        (
                input   wire                    adc_clock,
                input   wire    [W-1:0] adc_data,

                input   wire                    sys_clock,
                output  wire                    sys_frame,
                output  wire    [W-1:0] sys_data
        );

        wire    [W-1:0] int_q;
        reg             [W-1:0] int_data;
        
        reg                             state, int_rdreq, int_frame;
        wire                    int_wrfull, int_rdempty;

        dcfifo #(
                .intended_device_family("Cyclone III"),
                .lpm_numwords(16),
                .lpm_showahead("ON"),
                .lpm_type("dcfifo"),
                .lpm_width(W),
                .lpm_widthu(4),
                .rdsync_delaypipe(4),
                .wrsync_delaypipe(4),
                .overflow_checking("ON"),
                .underflow_checking("ON"),
                .use_eab("ON"),
                .write_aclr_synch("OFF")) fifo_unit (
                .aclr(1'b0),
                .data(adc_data),
                .rdclk(sys_clock),
                .rdreq((~int_rdempty) & int_rdreq),
                .wrclk(adc_clock),
                .wrreq(~int_wrfull),
                .q(int_q),
                .rdempty(int_rdempty),
                .wrfull(int_wrfull),
                .rdfull(),
                .rdusedw(),
                .wrempty(),
                .wrusedw());

        always @(posedge sys_clock)
        begin
                case (state)
                        1'b0:
                        begin
                                int_rdreq <= 1'b1;
                                int_frame <= 1'b0;
                                state <= 1'b1;
                        end

                        1'b1: 
                        begin
                                if (~int_rdempty)
                                begin
                                        int_data <= int_q;
                                        int_rdreq <= 1'b0;
                                        int_frame <= 1'b1;
                                        state <= 1'b0;
                                end
                        end
                endcase
        end
        
        assign  sys_frame = int_frame;
        assign  sys_data = int_data;

endmodule