source: trunk/MultiChannelUSB/i2c_fifo.v@ 69

module i2c_fifo
        (               
                input   wire                    clk, aclr,
                input   wire                    wrreq,
                input   wire    [15:0]  data,
                output  wire                    full,

                inout   wire                    i2c_sda,
                output  wire                    i2c_scl
        );

        wire                    int_rdempty, i2c_clk, start, stop;
        wire    [15:0]  int_q;

        reg                             int_rdreq, int_clken, int_sdo, int_scl, int_ack;
        reg             [15:0]  int_data;
        reg             [8:0]   counter;
        reg             [4:0]   state;

        assign i2c_clk = counter[8];

        assign i2c_sda = int_sdo ? 1'bz : 1'b0;
        assign i2c_scl = int_scl | (int_clken ? ~i2c_clk : 1'b0);       
//      assign i2c_scl = counter[8];    

        assign start = int_data[8];
        assign stop = int_data[9];

        dcfifo #(
                .intended_device_family("Cyclone III"),
                .lpm_numwords(16),
                .lpm_showahead("ON"),
                .lpm_type("dcfifo"),
                .lpm_width(16),
                .lpm_widthu(4),
                .rdsync_delaypipe(4),
                .wrsync_delaypipe(4),
                .overflow_checking("ON"),
                .underflow_checking("ON"),
                .use_eab("OFF"),
                .write_aclr_synch("OFF")) fifo_tx (
                .aclr(aclr),
                .data(data),
                .rdclk(i2c_clk),
                .rdreq((~int_rdempty) & int_rdreq),
                .wrclk(clk),
                .wrreq(wrreq),
                .q(int_q),
                .rdempty(int_rdempty),
                .wrfull(full),
                .rdfull(),
                .rdusedw(),
                .wrempty(),
                .wrusedw());
        
        always @ (posedge clk)
        begin
                counter <= counter + 9'd1;
        end

        always @ (posedge i2c_clk)
        begin
                case (state)
                        0:
                        begin
                                int_sdo <= 1'b1;
                                int_scl <= 1'b1;
                                int_rdreq <= 1'b1;
                                state <= 5'd1;
                        end

                        1: 
                        begin
                                if (~int_rdempty)
                                begin
                                        int_data <= int_q;
                                        int_rdreq <= 1'b0;
                                        state <= 5'd2;
                                end
                        end

                        2: 
                        begin
                                if (start)
                                begin
                                        int_sdo <= 1'b1;
                                        int_scl <= 1'b1;
                                        state <= 5'd3;
                                end
                                else
                                begin
                                        state <= 5'd5;
                                end
                        end
                
                        3:
                        begin // start
                                int_sdo <= 1'b0;
                                state <= 5'd4;
                        end

                        4:
                        begin
                                int_scl <= 1'b0;
                                state <= 5'd5;
                        end
                
                        5:
                        begin // data
                                int_clken <= 1'b1;
                                int_sdo <= int_data[7];
                                state <= 5'd6;
                        end

                        6:
                        begin
                                int_sdo <= int_data[6];
                                state <= 5'd7;
                        end

                        7:
                        begin
                                int_sdo <= int_data[5];
                                state <= 5'd8;
                        end

                        8:
                        begin
                                int_sdo <= int_data[4];
                                state <= 5'd9;
                        end

                        9:
                        begin
                                int_sdo <= int_data[3];
                                state <= 5'd10;
                        end

                        10:
                        begin
                                int_sdo <= int_data[2];
                                state <= 5'd11;
                        end

                        11:
                        begin
                                int_sdo <= int_data[1];
                                state <= 5'd12;
                        end

                        12:
                        begin
                                int_sdo <= int_data[0];
                                state <= 5'd13;
                        end
                        
                        13:
                        begin // ack
                                int_sdo <= 1'b1;
                                int_rdreq <= 1'b1;
                                state <= 5'd14;
                        end

                        14:
                        begin 
                                int_ack <= i2c_sda;
                                int_rdreq <= 1'b0;
                                if (stop | int_rdempty)
                                begin
                                        int_clken <= 1'b0;
                                        int_sdo <= 1'b0;
                                        int_scl <= 1'b0;
                                        state <= 5'd15;
                                end
                                else if (~int_rdempty)
                                begin
                                        int_data <= int_q;
                                        int_sdo <= int_q[7];
                                        state <= 5'd6;
                                end
                        end

                        15:
                        begin // stop
                                int_scl <= 1'b1;
                                state <= 5'd16;
                        end

                        16:
                        begin
                                int_sdo <= 1'b1;
                                state <= 5'd0;
                        end

                endcase
        end

endmodule