Version 1 (modified by 7 years ago) ( diff ) | ,
---|
Protos installation
Protos can be installed in 2 steps. First, you need to install an old release of LHAPDF (5.*.* not 6.*.*) and download the PDF sets that you would like to use. Second, you must proceed to the Protos installation.
LHAPDF 5.9.1 installation
- Download the tarball: lhapdf5.9.1.tgz
- Untar the tarball with the command:
tar xzf lhapdf5.9.1.tgz
. Normally a lhapdf591 folder must be created on your disk.
- Create a folder where the final production of the LHAPDF building will be put:
mkdir lhapdf
- Go to lhapdf591 and configure the package:
cd lhapdf591; ./configure --nopythext --shared-enabled --static--enabled --prefix=<absolute path of lhapdf>
where <absolute path of lhapdf> is the absolute path of lhapdf.
- Launch the building and cross the fingers :-):
make; make install
- Configure the environment variables:
export LHAPDF=<absolute_path_lhpadf>
,export PATH=$PATH:$LHAPDF/bin
export LD_LIBRARY_PATH=$LD_LIBRARY_PATH:$LHAPDF/lib
- Install PDF sets. This is a example of CTEQ6L1
cd $LHAPDF/shared; lhapdf-getdata CTEQ6L1.LHgrid
. The full list of CTEQ can be found here:lhapdf-getdata --list
Protos 2.2 installation
- Download the tarball:
- Untar the tarball
- Apply the patch
- Launch make
Attachments (3)
- lhapdf-5.9.1.tar.gz (1.2 MB ) - added by 7 years ago.
- Protos22.tar.gz (2.8 MB ) - added by 7 years ago.
- Protos22_patchEric.tar.gz (2.9 MB ) - added by 7 years ago.
Note:
See TracWiki
for help on using the wiki.